|
Muscle Maker Rubber Flooring |
| Manufacturing
Requirements (Back
to Top of this Page) |
- Tiles must be high pressure
molded as provided by The Mat King, Levittown, Long Island,, Long Island,
New York.
- Tiles must have staggered
interlocking every 12" to help prevent disengagement.
- Interlocking tiles to be functional
at 90-degree angle.
- Tiles must have life expectancy
against wear of ten (10) years.
- Tiles to have beveled borders
where required - full 12" border.
- Finish to be Pebble Grain.
|
| Test
Methods (Back
to Top of this Page) |
- Shore A durometer ASTM D2240
- Co-efficient of friction;
"British Portable Skid Resistance Tester" ASTM
E 303
- Compression Recovery ASTM
D2240
- Abrasion resistance - Taber
Abrader using CS-17 wheels under a pressure of 1,000 grams.
- ASTM E-648 Critical
Flux Radiant Class I & II
|
| Test
Results Summaries (Back
to Top of this Page) |
- Shore A Durometer 55 at 70
degrees F.
- Wet-Dynamic - not less than
30.
- Tensile Strength - not less
than 890 psi.
- Shrinkage not to exceed 1.1
after 7 days oven aging.
- Compression and recovery -
not less than 90%.
- Abrasion Resistance - Weight
loss: grams per revolution 0.0011.
- Specific Gravity - 1.52.
- Percentage Elongation - 510%
- 300% Modules (psi) - 575 psi.
- Tear Die "E" (ppi)
- 153 ppi.
- Critical Flux
Radiant Average of 23.5 cm. At .81 sq. cm Class I &
II
|
| |
|
Back
to Muscle Maker Rubber Flooring Product Page |
|
Back
to Interlocking Mats and Matting Index Page |
|
Back
to Industrial Mats and Matting |
|
Site Map: The Mat King
Web Site in Overview |
