GLOSSY URETHANE FINISH
Begin 48 hours after installation

ALWAYS WEAR GOGGLES, GLOVES AND SLIP RESISTANT SHOES WHEN USING THIS PRODUCT.

The floor should always be clean to minimize any slip hazard from build up of dust and tracked-in contaminates. When the floor is properly cleaned, you will notice increased traction.

Initial and Daily Maintenance

1. Install and maintain entry matting with a non-staining backing to reduce tracked-in dirt and contaminants.

2. Sweep with a soft bristle broom or microfiber dust mop the entire area to remove dust and debris.

3. Dilute LONCARE 2oz per gallon of cold tap water. Damp mop using a clean microfiber mop pad.

4. To remove scuff marks, BUFF area with a low speed machine or autoscrubber equipped with a clean contact pad until clean and dry.

5. Change buffing pads when they get clogged.

Note: Always use quality pH neutral cleaning products. Do not use abrasive pads, brushes or cleaning agents.

Revitalize Gloss (As Needed)
The length of time required for interim maintenance or revitalizing varies and is dependent upon usage and traffic.

1. Sweep with a soft bristle broom or microfiber dust mop the entire area to remove dust and debris.
2. Spray a fine mist of LONBUFF over a small area to be cleaned  (about 5 feet at a time).

1. Immediately BUFF sprayed area with a low speed machine quipped with a clean contact pad until clean and dry.
2. Change contact pads when they get clogged.
3. Once the surface is clean and completely dry, DRY BUFF with a contact pad on a low speed machine to enhance the luster.

Back to Impression Flooring Index

               

Site Map: The Mat King Web Site in Overview

 

THE MAT KING
740 West End Avenue; Suite 1
New York, NY 10025 USA

Phone: (646)998-4208
Fax: (646)998-4073
Phone: 800-442-6544
Fax: 800-Mats-Fax (628-7329)
Phone: 800-442-6544
Fax: 800-Mats-Fax (628-7329)